These sights provide a specific low-withness with the red/green dot sitting as low in the optic window as possible, reducing distractions and retaining target focus for your dot, no more measuring down to the 100th of an inch to figure out what specific front and rear sight you’ll need. The rear sight features a machined cavity on each side, allowing you to install with a vice and brass punch without the punch slipping off the sight.

The black serrated front and rear sights provide a precise shot when needed but act best as your secondary source sighting system by giving the least amount of distraction while using your primary red dot optic.

Features: 

– Correct height Low-Witness with specific red/green dots (Details Below)

– Black Serrated front and rear 

– Machined cavity for installation with a punch 

Note: If you want higher than low-witness, select the next size up (Height)

OPTIC SPECIFIC SIZING

ACRO P1/P2: Height .188" // Front Width .125" // Rear Notch .150"

RMR/SRO/407C/507C/508T: Height .269" // Front Width .125" // Rear Notch .150"

DPP: Height .369" // Front Width .125" // Rear Notch .150"

509T: Height .312" // Front Width .125" // Rear Notch .150"